Search results
Results from the WOW.Com Content Network
For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
where is the tap drill size, is the major diameter of the tap (e.g., 3 ⁄ 8 in for a 3 ⁄ 8-16 tap), and / is the thread pitch (1 ⁄ 16 inch in the case of a 3 ⁄ 8-16 tap). For a 3 ⁄ 8 -16 tap, the above formula would produce 5 ⁄ 16 , which is the correct tap drill diameter.
High-speed steel (HSS or HS) is a subset of tool steels, commonly used as cutting tool material. It is superior to high- carbon steel tools in that it can withstand higher temperatures without losing its temper (hardness).
ISO 965 (ISO general purpose metric screw thread—tolerances) is an International Organization for Standardization (ISO) standard for metric screw thread tolerances. [1] It specifies the basic profile for ISO general purpose metric screw threads (M) conforming to ISO 261.
The thread form is defined by flats at the tip and root of the thread form. This flat length is defined as the pitch divided by eight. The thread depth, which is from flat to flat is 0.6495 times the pitch. [4]
The backers of the Tyler Tap were able to interest St. Louis capitalist James W. Paramore—president of the St. Louis Cotton Compress Company—and his associates in the railroad, because they believed the line might result in lower shipping rates for cotton shipments from Texas to their compressors in St. Louis.
Is it correct to pluralize them, or should it be speed and feed? Wizard191 19:11, 1 December 2008 (UTC) Either one would work, but I vote for "speeds and feeds ...