enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   These drive fittings come in four common sizes: 1 ⁄ 4 inch, 3 ⁄ 8 inch, 1 ⁄ 2 inch, and 3 ⁄ 4 inch (referred to as "drives", as in "3 ⁄ 8 drive"). Despite being denominated in inches, these are trade names ( common product name ), and manufacturers construct them to 6.3 mm, 9.5 mm, 12.5 mm and 19 mm, having been rounded to a ...

3. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   A security Torx screw drive is a common modification to socket and cruciform style drives to make the fastener more tamper resistant by inserting a pin in the center of the female socket, requiring a tool with a corresponding hole to drive the fastener. This can also prevent attempts at turning the screw with a small flat-bladed screwdriver.

4. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   The internal-drive square socket for screws (as well as the corresponding triangular socket drive) had been conceived several decades before the invention of the Robertson screw and driver. An earlier patent covering both square-socket- and triangle-socket -drive wood screws, U.S. patent 161,390 , was issued to Allan Cummings of New York City ...

5. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   "Switched socket-outlets and connectors with or without interlock" applies to self-contained products that combine within a single enclosure, a socket-outlet or connector according to IEC 60309-1 or IEC 60309-2 and a switching device, with a rated operating voltage not exceeding 1000 VDC or VAC and 500 Hz, and a rated current not exceeding 800 A.

6. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   7 thumb screw 6-32 × 6 mm for 2.5” drive tray, expansion slots; 4 hexagon screw 6-32 × 6 mm for psu; 21 phillips screw 6-32 × 5 mm for motherboard, 3.5” harddisk tray; 12 phillips screw M3 × 5 mm for 2.5” harddrive; 16 KB5 x 10 mm for fans; 9 standoff 6-32 × 6.5 + 4 mm for motherboard; 1 positioning standoff 6-32 × 6.5 + 4 mm for ...

7. Floppy disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Floppy_disk_drive_interface

   The de facto standard for 3.5 inch drives uses a 34-pin header mating to an IDC Berg connector, collectively slightly smaller than the PCB edge pin connector and mating socket used for the 5¼ inch standard but with the same 34 pin definitions as the 5¼ inch standard. [7]