enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).

3. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.

4. Threaded pipe - Wikipedia

   en.wikipedia.org/wiki/Threaded_pipe

   Therefore many municipal plumbing codes restrict the use of threaded plastic pipe fittings. Both British standard and National pipe thread standards specify a thread taper of 1:16; the change in diameter is one sixteenth the distance travelled along the thread. The nominal diameter is achieved some small distance (the "gauge length") from the ...

5. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

6. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

7. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   AN fittings are a flare fitting, using 37° flared tubing to form a metal-to-metal seal. They are similar to other 37° flared fittings, such as JIC , which is their industrial variant. [ 2 ] The two are interchangeable in theory, though this is typically not recommended due to the exacting specifications and demands of the aerospace industry.