Search results
Results from the WOW.Com Content Network
In a parallel circuit, the voltage across each of the components is the same, and the total current is the sum of the currents flowing through each component. [1] Consider a very simple circuit consisting of four light bulbs and a 12-volt automotive battery. If a wire joins the battery to one bulb, to the next bulb, to the next bulb, to the ...
An RLC circuit is an electrical circuit consisting of a resistor (R), an inductor (L), and a capacitor (C), connected in series or in parallel. The name of the circuit is derived from the letters that are used to denote the constituent components of this circuit, where the sequence of the components may vary from RLC.
Shunt (electrical) A shunt is a device that is designed to provide a low-resistance path for an electrical current in a circuit. It is typically used to divert current away from a system or component in order to prevent overcurrent. Electrical shunts are commonly used in a variety of applications including power distribution systems, electrical ...
A power inverter, inverter, or invertor is a power electronic device or circuitry that changes direct current (DC) to alternating current (AC). [1] The resulting AC frequency obtained depends on the particular device employed. Inverters do the opposite of rectifiers which were originally large electromechanical devices converting AC to DC.
A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...
Basic design principle and circuit diagram for the rotating-coil AC voltage regulator. This is an older type of regulator used in the 1920s that uses the principle of a fixed-position field coil and a second field coil that can be rotated on an axis in parallel with the fixed coil, similar to a variocoupler.
The multiphase buck converter is a circuit topology where basic buck converter circuits are placed in parallel between the input and load. Each of the n "phases" is turned on at equally spaced intervals over the switching period. This circuit is typically used with the synchronous buck topology, described above.
The usual waveform of alternating current in most electric power circuits is a sine wave, whose positive half-period corresponds with positive direction of the current and vice versa (the full period is called a cycle). In certain applications, like guitar amplifiers, different waveforms are used, such as triangular waves or square waves.