Search results
Results from the WOW.Com Content Network
The NV5600 takes a special lubricant, not gear oil. The Mopar part number is 4874464. Transmissions specific 5W30. 5W30 motor oil is not recommended. 5W30 "synchromesh" only. Input Torque 550ft-lb; Weight 360lbs; Oil Capacity 9.5 Pints (10 w/optional filter) Close Ratio NV5600 Gearing: [1]
The Dana 20 is generally compatible with the "big hole" Dana 18. One exception is the version used with the THM400 in full-size Jeep trucks, which used a different spline number on the input gear. Applications: Jeep CJ; Jeep SJ; 1963-1979 Willys-Overland Jeepster; 1979 International Scout with 727TF AT uses the 23 spline 26 tooth gear.
2001–2007 New Venture Gear T850 — 5-speed manual transaxle; 2005–2018 Chrysler NSG370 transmission — 6-speed longitudinal manual; 1962–1993 New Process Gear NP435 — 4-speed longitudinal manual; 1987–1991 New Process Gear NP535 (also known as New Venture Gear NV2500) — 5-speed longitudinal manual
The New Venture Gear 3500, commonly called NV3500, is a 5-speed overdrive manual transmission manufactured by New Venture Gear and used by GM and Dodge in compact and full-size light trucks. It can be identified by its two-piece aluminum case with integrated bell housing and top-mounted tower shifter.
New Venture Gear was an automobile and light truck transmission company that was started in 1990 as the first-ever joint venture between any of the Big Three U.S. automakers. General Motors and Chrysler Corporation were the participants.
This design allows the vehicle to be driven (in “limp-in” mode) in the event of an electronic control system failure, or a situation that the Transmission Control Module (TCM) recognizes as potentially damaging to the transmission. On the 68RFE, fourth gear is used for limp-in instead of second and third. All RFE transmissions use Mopar ATF +4.
A handfull of other enhancements, part throttle 3rd gear tcc lockup was a big quality of life enhancement. The base design from the original Torqueflite remains essentially unchanged. The addition of a two-speed output shaft (overdrive unit) that is bolted to the back of the three-speed transmission has only two ratios: direct (1:1) and ...
A crossed helical gear is a gear that operate on non-intersecting, non-parallel axes. The term crossed helical gears has superseded the term spiral gears. There is theoretically point contact between the teeth at any instant. They have teeth of the same or different helix angles, of the same or opposite hand.