enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Genuit - Wikipedia

   en.wikipedia.org/wiki/Genuit

   Genuit Group plc, formerly Polypipe Group, is a manufacturer of plastic piping systems, for use in the residential, commercial, civils and infrastructure sectors.The piping systems are used for a variety of applications including drainage, plumbing, water supply, water management, cable management, heating and ventilation.

3. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   For example, DN20 is the size for copper pipe with an outside diameter of 19.05 mm or 3 ⁄ 4 inch. While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a ...

4. Reynolds 531 - Wikipedia

   en.wikipedia.org/wiki/Reynolds_531

   Reynolds 531 (pronounced 'five-three-one') is a brand name, registered to Reynolds Technology of Birmingham in the United Kingdom, for a manganese–molybdenum, medium-carbon steel tubing that was used in many quality applications, including race car chassis, aircraft components and, most famously, bicycle frame tubing. It is one of a number of ...

5. News, Politics, Sports, Mail & Latest Headlines - AOL.com

   homepage.aol.com

   Discover the latest breaking news in the U.S. and around the world — politics, weather, entertainment, lifestyle, finance, sports and much more.

6. Heat-shrink tubing - Wikipedia

   en.wikipedia.org/wiki/Heat-shrink_tubing

   Heat-shrink tubing (or, commonly, heat shrink or heatshrink) is a shrinkable plastic tube used to insulate wires, providing abrasion resistance and environmental protection for stranded and solid wire conductors, connections, joints and terminals in electrical wiring.

7. Production tubing - Wikipedia

   en.wikipedia.org/wiki/Production_tubing

   Tubing is a smaller diameter pipe that is run inside of the production casing. A packer is usually set at the lower end of the casing to prevent formation fluid from entering the annulus between the tubing and the casing. A packer is an elastomer cylinder that forms a pressure seal between the tubing and the casing.