Search results
Results from the WOW.Com Content Network
Torsion bar suspension inside Leopard 2 Schematic of a front axle highlighted to show torsion bar. A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end ...
Small, coiled torsion springs are often used to operate pop-up doors found on small consumer goods like digital cameras and compact disc players. Other more specific uses: A torsion bar suspension is a thick, steel torsion-bar spring attached to the body of a vehicle at one end and to a lever arm which attaches to the axle of the wheel at the ...
For 1967 the four was replaced with International's 266 cu in (4.4 L) V8 engine producing 154.8 hp (115 kW), rather than the overworked four, and given the name 908B (6,531 built, followed by 3,656 908C for model year 1968). The wheelbase was stretched to 115 in (2,920 mm), and the bed was longer as well, at 6 ft 8 in (2,030 mm).
The Plymouth Satellite is a mid-size automobile introduced in the 1965 model year as the top trim model in Plymouth's "B" platform Belvedere line. Available initially in two-door hardtop and convertible models, [1] the Satellite remained the top-of-the-line model until the 1967 model year.
The front suspension consisted of unequal length control arms with torsion bars, while the rear suspension used a live axle supported by asymmetric leaf springs. Chrysler used this design through the entire production of the Valiant and other A-body models, with revisions to the suspension components themselves for the 1962, 1967, 1968, and ...
Automotive suspension design is an aspect of automotive engineering, concerned with designing the suspension for cars and trucks. Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture
Swing axle suspensions often used leaf springs and shock absorbers, though later Mercedes-Benz applications used coil springs and the VW beetle swing axle was torsion bar sprung. One problem inherent in the swing axle concept is that it almost inevitably results in a very high roll centre which causes detrimental jacking effects and camber ...
The front suspension introduced Chrysler's Torsion-Aire Torsion bar suspension shared with all Chrysler products starting in 1957. In 1958, the optional engine was a "big block" 350 cu in (5.7 L) called the "Golden Commando" with two four-barrel carburetors producing 305 hp (227 kW).