Search results
Results from the WOW.Com Content Network
The IP-address could be 91.198.174.2. In this example, none of the internal routers know the route to that host, so they will forward the packet through router1's gateway or default route. [1] Every router on the packet's way to the destination will check whether the packet's destination IP-address matches any known network routes. If a router ...
The gateway address must be configured on each host. The network host IP interface binds the gateway address to the MAC address of the physical gateway by broadcasting IP datagrams and caching the MAC address of the reply from the gateway in an ARP table stored on the host. The gateway address may be added manually.
Public IP addresses may be used for communication between hosts on the global Internet. In a home situation, a public IP address is the IP address assigned to the home's network by the ISP. In this case, it is also locally visible by logging into the router configuration. [31] Most public IP addresses change, and relatively often.
IP packets originating from or addressed to a private IP address cannot be routed through the public Internet. Private addresses are often seen as enhancing network security for the internal network since use of private addresses internally makes it difficult for an external host to initiate a connection to an internal system.
IP addressing entails the assignment of IP addresses and associated parameters to host interfaces. The address space is divided into subnets , involving the designation of network prefixes. IP routing is performed by all hosts, as well as routers , whose main function is to transport packets across network boundaries.
A router is considered a layer-3 device because its primary forwarding decision is based on the information in the layer-3 IP packet, specifically the destination IP address. When a router receives a packet, it searches its routing table to find the best match between the destination IP address of the packet and one of the addresses in the ...
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
The route evaluation process in each router uses the longest prefix match method to obtain the most specific route. The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the ...