Ad
related to: crankcase vent vent locations diagramebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A crankcase ventilation system (CVS) removes unwanted gases from the crankcase of an internal combustion engine. The system usually consists of a tube, a one-way valve and a vacuum source (such as the inlet manifold). The unwanted gases, called "blow-by", are gases from the combustion chamber which have leaked past the piston rings. Early ...
A crankcase is the housing in a piston engine that surrounds the crankshaft. In most modern engines, the crankcase is integrated into the engine block. Two-stroke engines typically use a crankcase-compression design, resulting in the fuel/air mixture passing through the crankcase before entering the cylinder(s). This design of the engine does ...
An oil catch can is fitted in line of the crank case breather system. It is placed in between the breather outlet and the intake system. As the crank vapors pass through the catch can the oil droplets, un-burnt fuel, and water vapor condense and settle in the tank. This stops them from reaching the intake and causing the issues mentioned above.
The first effort at controlling pollution from automobiles was the PCV (positive crankcase ventilation) system. This draws crankcase fumes heavy in unburned hydrocarbons – a precursor to photochemical smog – into the engine's intake tract so they are burned rather than released unburned from the crankcase into the atmosphere. Positive ...
Radial engines have cylinders mounted radially around a central crankcase. Rotary engines have a similar configuration, except that the crankshaft is fixed and the cylinders rotate around it. (This is different from the Wankel engine configuration described below.) Radial and rotary engine designs were widely used in early aircraft engines.
The CVH is known for producing excessive sludge if the service schedule is ignored or if poor quality oil is used. The cause is the design of the crankcase ventilation circuit, which Ford revised several times over the engine's lifetime but never completely cured. Due to this, camshaft and tappet wear problems are common.
This is known as a positive crankcase ventilation system, in which the gases are burned with the fuel/air mixture. The intake manifold has historically been manufactured from aluminium or cast iron, but use of composite plastic materials is gaining popularity (e.g. most Chrysler 4-cylinders, Ford Zetec 2.0, Duratec 2.0 and 2.3, and GM's Ecotec ...
The valvetrain layout is largely dependent on the location of the camshaft. The common valvetrain configurations for piston engines, in order from oldest to newest, are: Flathead engine : The camshaft and the valves are located in the engine block below the combustion chamber .
Ad
related to: crankcase vent vent locations diagramebay.com has been visited by 1M+ users in the past month