Search results
Results from the WOW.Com Content Network
For example, if a TNO is incorrectly assumed to have a mass of 3.59 × 10 20 kg based on a radius of 350 km with a density of 2 g/cm 3 but is later discovered to have a radius of only 175 km with a density of 0.5 g/cm 3, its true mass would be only 1.12 × 10 19 kg.
11 meters – approximate width of a doubles tennis court; 15 meters – width of a standard FIBA basketball court; 15.24 meters – width of an NBA basketball court (50 feet) 18.44 meters – distance between the front of the pitcher's rubber and the rear point of home plate on a baseball field (60 feet, 6 inches) [126]
Grain size (or particle size) is the diameter of individual grains of sediment, or the lithified particles in clastic rocks. The term may also be applied to other granular materials . This is different from the crystallite size, which refers to the size of a single crystal inside a particle or grain.
For stars with similar metallicity to the Sun, the theoretical minimum mass the star can have, and still undergo fusion at the core, is estimated to be about 75 M J. [13] [14] When the metallicity is very low, however, a recent study of the faintest stars found that the minimum star size seems to be about 8.3% of the solar mass, or about 87 M J.
Specific modulus is a materials property consisting of the elastic modulus per mass density of a material. It is also known as the stiffness to weight ratio or specific stiffness . High specific modulus materials find wide application in aerospace applications where minimum structural weight is required.
The units of an R-value (see below) are usually not explicitly stated, and so it is important to determine from context which units are being used: an R-value expressed in I-P (inch-pound) units [13] is about 5.68 times larger than when expressed in SI units, [14] so that, for example, a window that is R-2 in I-P units has an RSI of 0.35 (since ...
The size of wafers for photovoltaics is 100–200 mm square and the thickness is 100–500 μm. [10] Electronics use wafer sizes from 100 to 450 mm diameter. The largest wafers made have a diameter of 450 mm, [ 11 ] but are not yet in general use.
It is first determined whether M is indeed greater than 1.0 by calculating M from the subsonic equation. If M is greater than 1.0 at that point, then the value of M from the subsonic equation is used as the initial condition for fixed point iteration of the supersonic equation, which usually converges very rapidly. [ 8 ]