Search results
Results from the WOW.Com Content Network
A temperature coefficient describes the relative change of a physical property ... The thermal coefficient of electrical circuit parts is sometimes specified as ppm/ ...
In practice, the resistance will vary with time and external conditions. Resistance will vary with temperature. Carbon film resistors have temperature coefficients of several hundred parts per million per kelvin. [2] Some wirewound resistors have coefficients of 10 ppm/K. Some off-the-shelf metal foil resistors can be as low as 0.2 ppm/K. [3]
Temperature coefficients as low as 1.5–2.0 ppm/°C can be obtained with bandgap references. [a] However, the parabolic characteristic of voltage versus temperature means that a single figure in ppm/°C does not adequately describe the behavior of the circuit. Manufacturers' data sheets show that the temperature at which the peak (or trough ...
At 1 ppm the solution is a very pale yellow. As the concentration increases the colour becomes a more vibrant yellow, then orange, with the final 10,000 ppm a deep red colour. In science and engineering , the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities , e.g. mole fraction or ...
The EIA RS-198 standard codes ceramic class 1 capacitors with a three character code that indicates temperature coefficient. The first letter gives the significant figure of the change in capacitance over temperature (temperature coefficient α) in ppm/K. The second character gives the multiplier of the temperature coefficient.
Temperature coefficient, in parts per million per Kelvin (ppm/K) or per degree Celsius (ppm/C) This page was last edited on 13 ...
Depending on specific composition the resistivity is about 1.4 μΩ·m and temperature coefficient is +49 ppm/K (+49 ...
Common grades of Invar have a coefficient of thermal expansion (denoted α, and measured between 20 °C and 100 °C) of about 1.2 × 10 −6 K −1 (1.2 ppm/°C), while ordinary steels have values of around 11–15 ppm/°C. [citation needed] Extra-pure grades (<0.1% Co) can readily produce values as low as 0.62–0.65 ppm/°C.