Search results
Results from the WOW.Com Content Network
Aluminium alloys are often used due to their high strength-to-weight ratio, corrosion resistance, low cost, high thermal and electrical conductivity.There are a variety of techniques to join aluminium including mechanical fasteners, welding, adhesive bonding, brazing, soldering and friction stir welding (FSW), etc. Various techniques are used based on the cost and strength required for the joint.
Many metals and thermoplastics can be welded, but some are easier to weld than others (see Rheological weldability). A material's weldability is used to determine the welding process and to compare the final weld quality to other materials. Weldability is often hard to define quantitatively, so most standards define it qualitatively.
The symbolic representation of a V weld of chamfered plates in a technical drawing. The symbols and conventions used in welding documentation are specified in national and international standards such as ISO 2553 Welded, brazed and soldered joints -- Symbolic representation on drawings and ISO 4063 Welding and allied processes -- Nomenclature of processes and reference numbers.
Gas metal arc welding Man welding a metal structure in a newly constructed house in Bengaluru, India. Arc welding is a welding process that is used to join metal to metal by using electricity to create enough heat to melt metal, and the melted metals, when cool, result in a joining of the metals.
Typically, after welding, the properties near the weld are those of 6061-T4, a loss of strength of around 40%. The material can be re-heat-treated to restore near -T6 temper for the whole piece. After welding, the material can naturally age and restore some of its strength as well.
Oxygas welding station (keep cylinders and hoses away from the flame) Gas welding/cutting goggles and safety helmet. Oxyacetylene welding/cutting is generally considered not to be difficult, but there are a good number of subtle safety points that should be learned such as: More than 1/7 the capacity of the cylinder should not be used per hour.
The weld access hole or rat hole is a structural engineering technique in which a part of the web of an I-beam or T-beam is cut out at the end or ends of the beam. The hole in the web allows a welder to weld the flange to another part of the structure with a continuous weld the full width on both top and bottom sides of the flange.
Slag forms from the use of a flux, which is why this type of defect usually occurs in welding processes that use such flux, such as shielded metal arc welding, flux-cored arc welding, and submerged arc welding; but it can also occur in gas metal arc welding. This defect usually occurs in welds that require multiple passes when there is poor ...