Search results
Results from the WOW.Com Content Network
The digital capacitive technology is based on a non-contacting ceramic sensor mounted inside the load cell body. As the load cell contains no moving parts and the ceramic sensor is not in contact with the load cell body, the load cell tolerates very high overloads (up to 1000%), sideloads, torsion, and stray welding voltages. [3]
A 'brake' dynamometer applies variable load on the prime mover (PM) and measures the PM's ability to move or hold the RPM as related to the "braking force" applied. It is usually connected to a computer that records applied braking torque and calculates engine power output based on information from a "load cell" or "strain gauge" and a speed ...
A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters.
The Elf was marketed as the Isuzu NPR and Chevrolet/GMC W series, each available with either the 4BD2T 3.9-liter turbo-diesel engine until 1998, the 4HE1 4.8-liter turbo-diesel engine from 1998 to 2004, the 4HK1 5.2-liter turbo-diesel engine from 2005.
It is a one-to-one relationship with an offset of -100 kPa for boost pressure. Thus, a MAP sensor will always read 100 kPa more than a boost sensor measuring the same conditions. A MAP sensor will never display a negative reading because it is measuring absolute pressure, where zero is the total absence of pressure.
LHDs are available in both diesel and electric versions. The diesel version is easily transportable from one location to another and has diesel engines with a power drive of 75 to 150 HP or more. Engines are either water- or air-cooled. LHD with electric motors as drives have a general capacity of 75 to 150 HP. These are operative at a medium ...
MAF sensor in a 2006-2015 automotive diesel engine. A mass (air) flow sensor (MAF) is a sensor used to determine the mass flow rate of air entering a fuel-injected internal combustion engine. The air mass information is necessary for the engine control unit (ECU) to balance and deliver the correct fuel mass to the engine. Air changes its ...
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...