Search results
Results from the WOW.Com Content Network
The H1 lamp uses a P14.5s base in accord with IEC 60061. [1] This is a round metal prefocus base 14.5 mm in diameter with a flat and two dimples so the H1 can be installed in a lamp only in the one correct orientation. There is one 6.35 mm male spade terminal in the center of the base, through which power is supplied.
Bulbs used for headlamps, turn signals and brake lamps may be required to comply with international and national regulations governing the types of lamps used. Other automotive lighting applications such as auxiliary lamps or interior lighting may not be regulated, but common types are used by many automotive manufacturers.
This file contains additional information, probably added from the digital camera or scanner used to create or digitize it. If the file has been modified from its original state, some details may not fully reflect the modified file.
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...
Diagram of a high-pressure sodium lamp A high-pressure sodium lamp, Philips Master SDW-T 100W. Various types of chemistry are used in the arc tubes of HID lamps, depending on the desired characteristics of light intensity, correlated color temperature, color rendering index (CRI), energy efficiency, and lifespan.
Typically, bulbs of 21 to 27 watts producing 280 to 570 lumens (22 to 45 mean spherical candlepower) are used for stop, turn, reversing and rear fog lights, while bulbs of 4 to 10 W, producing 40 to 130 lm (3 to 10 mscp) are used for tail lights, parking lights, side marker lights and side turn signal repeaters. [citation needed]
A sticker that is half-red and half-white indicates a pulse start metal halide lamp (PSMH). Green is also used on HPS units in Canada. Gray indicates that the fixture is of an LED type. In addition to being colour-coded, newer NEMA stickers also state the lamp type abbreviation just below the lamp's wattage (e.g. HPS, LED).
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...