Search results
Results from the WOW.Com Content Network
As the plate is pressed in, the teeth are all driven into the wood fibers simultaneously, and the compression between adjacent teeth reduces the tendency of the wood to split. A truss connector plate is manufactured from ASTM A653/A653M, A591, A792/A792M, or A167 structural quality steel and is protected with zinc or zinc-aluminum alloy ...
Both quantitative and qualitative tests for solderability exist. [6] The two most common testing methods are the 'dip and look' method and wetting balance analysis.In both of these tests, the soldered pieces undergo an accelerated aging process before being tested for solderability, to take into consideration the time a component was in storage prior to mounting to final assembly.
Soldering copper pipes using a propane torch and a lead-free solder. Solder is a metallic material that is used to connect metal workpieces. The choice of specific solder alloys depends on their melting point, chemical reactivity, mechanical properties, toxicity, and other properties.
Copper is a good choice for gutters and downspouts because it makes strong leak-proof joints. Gutters and downspouts made with copper are expected to outlast other metal materials and plastics. Even in corrosion-prone seacoast environments or in areas with acid rain or smog, copper gutters and downspouts can provide 50 years or more of service ...
Galvanized surface with visible spangle Galvanization ( also spelled galvanisation ) [ 1 ] is the process of applying a protective zinc coating to steel or iron , to prevent rusting . The most common method is hot-dip galvanizing , in which the parts are coated by submerging them in a bath of hot, molten zinc.
Production of galvannealed sheet steel begins with hot dip galvanization of sheet steel. After passing through the galvanizing zinc bath the sheet steel passes through air knives to remove excess zinc, and is then heated in an annealing furnace for several seconds causing iron and zinc layers to diffuse into one another causing the formation of zinc-iron alloy layers at the surface.
Further alternating layers of wood and steel can be used to produce an even stronger beam. The metal plates within the beam are known as flitch plates. Flitch beams were used as a cost-effective way to strengthen long-span wooden beams, and have been largely supplanted by more recent technology.
The boundary between the solder and the workpiece in a good joint will have a low angle. This indicates good wetting and minimal use of solder, and therefore minimal heating of heat sensitive components. A joint may be good, but if a large amount of unnecessary solder is used, then excess heating was obviously required.