enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 802.11 frame types - Wikipedia

   en.wikipedia.org/wiki/802.11_Frame_Types

   Generic 802.11 Frame. The very first two octets transmitted by a station are the Frame Control. The first three subfields within the frame control and the last field are always present in all types of 802.11 frames. These three subfields consist of two bits Protocol Version subfield, two bits Type subfield, and four bits Subtype subfield.

3. Ethernet frame - Wikipedia

   en.wikipedia.org/wiki/Ethernet_frame

   Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport

4. Frame check sequence - Wikipedia

   en.wikipedia.org/wiki/Frame_check_sequence

   By far the most popular FCS algorithm is a cyclic redundancy check (CRC), used in Ethernet and other IEEE 802 protocols with 32 bits, in X.25 with 16 or 32 bits, in HDLC with 16 or 32 bits, in Frame Relay with 16 bits, [3] in Point-to-Point Protocol (PPP) with 16 or 32 bits, and in other data link layer protocols.

5. Trilogy of Error - Wikipedia

   en.wikipedia.org/wiki/Trilogy_of_Error

   Lisa shows Homer her project for the school science fair, a grammar robot named Linguo, which Homer breaks by pouring beer down his throat. Shortly after, Marge accidentally severs Homer's thumb as she is cooking, and Santa's Little Helper runs around with the severed thumb, forcing Homer to chase him for it.

6. Frame Relay - Wikipedia

   en.wikipedia.org/wiki/Frame_Relay

   The frames in Frame Relay contain an expanded link layer address field that enables Frame Relay nodes to direct frames to their destinations with minimal processing. The elimination of functions and fields over X.25 allows Frame Relay to move data more quickly, but leaves more room for errors and larger delays should data need to be retransmitted.

7. Bleed (printing) - Wikipedia

   en.wikipedia.org/wiki/Bleed_(printing)

   1. Trim; where the product will be cut. 2. Bleed; the zone outside the trim area. 3. Margin; the zone inside the trim area. In printing, bleed is printing that goes beyond the edge of where the sheet will be trimmed.