Ad
related to: single phase current to three pin box extension converter plate design
Search results
Results from the WOW.Com Content Network
IEC 60906-1-plug. IEC 60906-1 (IEC designation "Type N") [1] is an international standard designed "to provide a standard for a safe, compact and practical 16 A 250 V AC system of plugs and socket-outlets that could be accepted by many countries as their national standard, even if not in the near future."
The socket is rectangular, with lateral key pins and indentations to maintain polarisation, and to prevent insertion of a plug with different current ratings. Three single-phase general purpose connectors were rated 10 A, 16 A and 20 A; and a three-phase industrial connector rated 10 A; all of them have different key-pin positioning so plugs ...
IEC 62196-2 describes this configuration with operating currents up to 63 A, allowing a maximum current of 70 A only for single-phase applications. Configuration type 2 differs from the first proposal by Mennekes that was presented in the German standard VDE-AR-E 2623-2-2 that was published in 2009 and withdrawn in 2012, when the German version ...
The first British standard for domestic three-pin plugs was BS 317 Hand-Shield and Side Entry Pattern Three-Pin Wall Plugs and Sockets (Two Pin and Earth Type) published in 1928. This was superseded in 1930 by BS 372 Side-Entry Wall Plugs and Sockets for Domestic Purposes Part II which states that there are only minor alterations from BS 317.
With single-phase sockets (T11, T13, T21, T23) the protective collar is 13 mm (+5 mm) deep, with three-phase sockets (T15, T25) 17.5 mm (+1 mm) deep. Dimensions of the connector Plugs according to T11 and T21 are between 13 mm and 14.5 mm wide, those according to T13 and T23 between 14.5 mm and 20 mm wide.
This allows one to choose single-phase AC power at either 110–120 volts between phase and neutral or 220–240 volts between phase and phase. Since these two modes do not need three phases there is also a dark yellow-orange four-pin connector available designed for a single-phase 110–120 or 220–240 volt load.
When viewing a plug from the rear, and the earth pin downwards, the top left pin is active and the top right pin is neutral. The shank of the active and neutral pins of every 10 amp and 15 amp flat-pin plug sold after 3 April 2005 are required to be insulated, in accordance with AS/NZS 3112:2000.
The Type 2 connector has a maximum power output for 43 kW and can handle both single-, dual- and three-phase AC power. The IEC 62196-2 Type 1 connector (codified under SAE J1772) is the corresponding standard for single-phase AC charging in the United States, Canada, and South Korea. [12] J1772 has a maximum output of 19.2 kW. [13]
Ad
related to: single phase current to three pin box extension converter plate design