Search results
Results from the WOW.Com Content Network
On one hand, intervening on the source is possible by using switching control techniques (increasing the efficiency), redesigning the circuit (costly and time demanding) and using soft switching transition. On the other hand, by adding external or internal filters (also costly) it is possible to address the propagation path. Fig. 1.
The curve representing the power limit for the load for the range of current and voltage magnitudes in which the load circuit may safely operate Battery chargers are the largest single application for current controlled power supplies requiring either constant-current or constant-power output characteristics.
Example Ladder Logic Diagram. The schematic diagrams for relay logic circuits are often called line diagrams, because the inputs and outputs are essentially drawn in a series of lines. A relay logic circuit is an electrical network consisting of lines, or rungs, in which each line or rung must have continuity to enable the output device. A ...
Zero-crossing control (or burst-fire control) is an approach for electrical control circuits that starts operation with the AC load voltage at close to 0 volts in the AC cycle. [1] This is in relation to solid-state relays, such as TRIACs and silicon controlled rectifiers . [ 1 ]
AC contactor for pump application. A contactor is an electrically controlled switch used for switching an electrical power circuit. [1] A contactor is typically controlled by a circuit which has a much lower power level than the switched circuit, such as a 24-volt coil electromagnet controlling a 230-volt motor switch.
A simple electric circuit made up of a voltage source and a resistor. Here, =, according to Ohm's Law. In the theory of electrical networks, a dependent source is a voltage source or a current source whose value depends on a voltage or current elsewhere in the network.
A typical example are Howland current source [2] and its derivative Deboo integrator. [3] In the last example (Fig. 1), the Howland current source consists of an input voltage source, V IN, a positive resistor, R, a load (the capacitor, C, acting as impedance Z) and a negative impedance converter INIC (R 1 = R 2 = R 3 = R and the op-amp).
A switched capacitor (SC) is an electronic circuit that implements a function by moving charges into and out of capacitors when electronic switches are opened and closed. . Usually, non-overlapping clock signals are used to control the switches, so that not all switches are closed simulta