Search results
Results from the WOW.Com Content Network
The old 2.5 L formula had been retained for International Formula racing, but this did not achieve much success until the introduction of the Tasman Series in Australia and New Zealand during the winter season, leaving the 1.5 L cars as the fastest single seaters in Europe during this time. The power range was between 150 hp (112 kW) and 225 hp ...
1.6 L (1,598 cc) Cylinder bore: 80 mm (3.15 in) Piston stroke: 53 mm (2.09 in) Cylinder block material: Aluminum alloy: Cylinder head material: Aluminum alloy: Valvetrain: 24-valve (four-valves per cylinder), DOHC: Combustion; Turbocharger: Hybrid turbocharger with typical 3.5-5.0 bar boost pressure: Fuel system: 500 bar (7,252 psi) gasoline ...
The engines have been in use since the 2015 Formula One season, initially run by the then newly re-established McLaren Honda works team. [1] Over years of development, power unit output was increased from approximately 760 to over 1,000 horsepower while utilising the same amount of fuel, as mandated by enforced technical regulations (Fuel Mass ...
The following is a list of Formula One engine manufacturers. In Formula One motor racing, engine or power unit manufacturers are people or corporate entities which are credited as the make of Formula One engines that have competed or are intended to compete in the FIA Formula One World Championship. A constructor of an engine owns the ...
Mercedes PU106 Hybrid Power Unit on display at the Silverstone Experience. The Mercedes V6 hybrid Formula One power unit is a series of 1.6-liter, hybrid turbocharged V6 racing engines which features both a kinetic energy recovery system (MGU-K) and a heat energy recovery system (MGU-H), developed and produced by Mercedes-AMG High Performance Powertrains for use in Formula One.
The Renault E-Tech R.E. Series (previously known as Renault Energy F1, Renault R.E. and Renault E-Tech) is a 1.6-liter, hybrid turbocharged V6 racing engine developed and produced by Renault Sport F1 in partnership with Mecachrome for the FIA Formula One World Championship. [2]
The TJ and CA series are a family of naturally-aspirated V10 and V8 Formula One racing engines, in both 2.4-litre and 3-litre engine configurations, designed and developed by Cosworth; and produced between 2005 and 2013. [2] The customer engines were used by Minardi, Red Bull, Toro Rosso, Williams, Lotus, HRT, Virgin, and Marussia.
The HB is a series of 3.5-litre, naturally-aspirated V8 Formula One racing engines, designed, developed and produced by Cosworth, in partnership with Ford; and used between 1989 and 1994. The customer engines were used by Benetton , Fondmetal , McLaren , Lotus , Minardi , Footwork , Simtek , and Larrousse .