Search results
Results from the WOW.Com Content Network
A circular buffer can be implemented using a pointer and three integers: [4] buffer start in memory; buffer capacity (length) write to buffer index (end) read from buffer index (start) This image shows a partially full buffer with Length = 7: This image shows a full buffer with four elements (numbers 1 through 4) having been overwritten:
Buffer capacity falls to 33% of the maximum value at pH = pK a ± 1, to 10% at pH = pK a ± 1.5 and to 1% at pH = pK a ± 2. For this reason the most useful range is approximately p K a ± 1. When choosing a buffer for use at a specific pH, it should have a p K a value as close as possible to that pH.
In computer science, a data buffer (or just buffer) is a region of memory used to store data temporarily while it is being moved from one place to another. Typically, the data is stored in a buffer as it is retrieved from an input device (such as a microphone) or just before it is sent to an output device (such as speakers); however, a buffer may be used when data is moved between processes ...
This page was last edited on 6 April 2017, at 05:47 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may ...
Heat capacity: C p: Energy per unit temperature change J/K L 2 M T −2 Θ −1: extensive Heat flux density: ϕ Q: Heat flow per unit time per unit surface area W/m 2: M T −3: Illuminance: E v: Wavelength-weighted luminous flux per unit surface area lux (lx = cd⋅sr/m 2) L −2 J: Impedance: Z: Resistance to an alternating current of a ...
A unit for a large amount of data can be formed using either a metric or binary prefix with a base unit. For storage, the base unit is typically byte. For communication throughput, a base unit of bit is common. For example, using the metric kilo prefix, a kilobyte is 1000 bytes and a kilobit is 1000 bits.
In digital electronics, a tri-state or three-state buffer is a type of digital buffer that has three stable states: a high output state, a low output state, and a high-impedance (Hi-Z) state. In the high-impedance state, the output of the buffer is disconnected from the output bus, allowing other devices to drive the bus without interference ...
Alkalinity can be measured by titrating a sample with a strong acid until all the buffering capacity of the aforementioned ions above the pH of bicarbonate or carbonate is consumed. This point is functionally set to pH 4.5. At this point, all the bases of interest have been protonated to the zero level species, hence they no longer cause ...