Search results
Results from the WOW.Com Content Network
The electric overhead garage door opener was invented by C.G. Johnson in 1926 in Hartford City, Indiana. [1] Electric Garage Door openers did not become popular until Era Meter Company of Chicago offered one after World War II where the overhead garage door could be opened via a key pad located on a post at the end of the driveway or a switch inside the garage.
Chamberlain's "myQ" technology is embedded in garage door openers and lights, [5] can be added to Wi-Fi networks to control these devices and is being incorporated into future home products, all through a monthly subscription. [6]
Remote controls send a digital code word to the receiver. If the receiver determines the codeword is acceptable, then the receiver will actuate the relay, unlock the door, or open the barrier. Simple remote control systems use a fixed code word; the code word that opens the gate today will also open the gate tomorrow.
The system typically features three buttons, most often found on the driver-side visor or on the overhead console, which can be programmed via a training sequence to replace existing remote controls. It is compatible with most RF-controlled garage door openers, as well as home automation systems such as those based on the X10 protocol.
The mechanism actuating the transition between these two states (open or closed) is usually (there are other types of actions) either an "alternate action" (flip the switch for continuous "on" or "off") or "momentary" (push for "on" and release for "off") type. A switch may be directly manipulated by a human as a control signal to a system ...
Wall-mounted electromagnetic door holder securing a door in the open position. An electromagnetic door holder (electromagnetic door holder and release or hold-open device, sometimes informally called a mag hold open or electric doorstop) is a simple electromechanical mechanism which can be used to hold a fire door or security door open until given a signal to release.
While the switch is turned on, the key is held by the interlock attached to the disconnecting switch. To open the kiln door, the switch is first opened, which releases the key. The key can then be used to unlock the kiln door. While the key is removed from the switch interlock, a plunger from the interlock mechanically prevents the switch from ...
A rack and pinion has roughly the same purpose as a worm gear with a rack replacing the gear, in that both convert torque to linear force. However the rack and pinion generally provides higher linear speed — since a full turn of the pinion displaces the rack by an amount equal to the pinion's pitch circle whereas a full rotation of the worm screw only displaces the rack by one tooth width.