Search results
Results from the WOW.Com Content Network
The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per minute (SCCM). In US customary units and imperial units, volumetric flow rate is often expressed as cubic feet per second (ft 3 /s) or gallons per minute (either US or imperial definitions).
Using Boyle's law, the equivalent GGE at 3,600 psi (25 MPa) is 0.51 cubic feet (14 litres; 3.8 US gallons). The National Conference of Weights & Measurements (NCWM) has developed a standard unit of measurement for compressed natural gas, defined in the NIST Handbook 44 Appendix D as follows: "1 Gasoline [US] gallon equivalent (GGE) means 2.567 ...
This regulation defines a standard cubic foot, for compressed or liquefied gases in refillable cylinders other than LPG by, "A standard cubic foot of gas is defined as a cubic foot at a temperature of 21 °C (70 °F) and a pressure of 101.325 kilopascals [kPa] (14.696 psia)".
The United States Geological Survey gives a figure of 6,000 cubic feet (170 cubic metres) of typical natural gas. [ 2 ] Due to the risk of confusion The Society of Petroleum Engineers recommends in their style guide that abbreviations or prefixes M or MM are not used for barrels of oil or barrel of oil equivalent, but rather that thousands ...
The cubic foot (symbol ft 3 or cu ft) [1] is an imperial and US customary (non-metric) unit of volume, used in the United States and the United Kingdom.It is defined as the volume of a cube with sides of one foot (0.3048 m) in length, or exactly 28.316 846 592 L, which is very close to 1 / 35 of a cubic metre).
AMFA specifies the energy content of 100 cubic feet of natural gas to be equal to 0.823 gallons-equivalent of natural gas, and the gallon equivalency of natural gas is considered to have a fuel content, similar to that for alcohol fuels, equal to 0.15 gallons of fuel.
With C v = 1.0 and 200 psia inlet pressure, the flow is 100 standard cubic feet per minute (scfm). The flow is proportional to the absolute inlet pressure, so the flow in scfm would equal the C v flow coefficient if the inlet pressure were reduced to 2 psia and the outlet were connected to a vacuum with less than 1 psi absolute pressure (1.0 ...
Actual cubic feet per minute (ACFM) is a unit of volumetric flow. It is commonly used by manufacturers of blowers and compressors. [1] This is the actual gas delivery with reference to inlet conditions, whereas cubic foot per minute (CFM) is an unqualified term and should only be used in general and never accepted as a specific definition without explanation.