enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Trailer brake controller - Wikipedia

   en.wikipedia.org/wiki/Trailer_brake_controller

   The trailer in this case usually has either electric friction brakes or electric-hydraulic trailer brake actuators. Most basic brake controllers will generally have a plus-minus gain adjustment. The tow vehicle operator sets the gain as high as possible but without the trailer brakes locking up after making a few test stops.

3. Electric friction brake - Wikipedia

   en.wikipedia.org/wiki/Electric_friction_brake

   Adjustment of the brake is done through the adjuster (6) which basically is a screw that can be accessed when the brake is assembled. The adjustment is necessary to make sure that the brake is working as expected and not applying brake force when not expected by having too tight margins while still retaining a good responsiveness from the brake.

4. Ford TowCommand - Wikipedia

   en.wikipedia.org/wiki/Ford_TowCommand

   With adjustable +/- trailer braking gain in a digital readout from 0.0 (no trailer brakes) to 10.0 (full trailer braking) in 0.5 increments and a manual override lever (to test trailer braking action), the Ford 'built into the dash' TBC provides smooth braking even when pulling up to a 15,000 lb 4-axle conventional (receiver mounted) or 26,000 ...

5. Air brake (road vehicle) - Wikipedia

   en.wikipedia.org/wiki/Air_brake_(road_vehicle)

   The trailer brake consists of a direct two-line system: the supply line and the separate control or service line. The supply line receives air from the prime mover park brake air tank via a park brake relay valve and the control line is regulated via the trailer-brake relay valve. The operating signals for the relay are provided by the prime ...

6. S-cam - Wikipedia

   en.wikipedia.org/wiki/S-cam

   Generally speaking, a tractor trailer requires more brakes than a typical vehicle, so making the brakes as simple and as cost effective as possible is very important. [citation needed] S-cams are very efficient at keeping brakes maintained because as the brake pad wears, the S-cam rotates more and causes the pads to further.

7. Overrun brake - Wikipedia

   en.wikipedia.org/wiki/Overrun_brake

   An overrun brake (called a surge brake when invented) is a brake system commonly used on small trailers, where the motion of the trailer with respect to the towing vehicle is used to actuate the brake. The early systems were fitted with a spring system which was not very effective.