Ads
related to: gm ring & pinion
Search results
Results from the WOW.Com Content Network
The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.
The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.
Ring gear diameter: 9 3 ⁄ 4 " Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1 ...
GM began making 4x4 Chevrolet Kodiaks and GMC Topkicks that utilize a Dana 70 front axle for the 2005-2009 models. These Dana 70 axles had open knuckles and ball joints . The Dana 70 axle only came with 5.13:1, 4.88,5.31 [ citation needed ] gear ratios and had a GAWR of [ citation needed ] these axles were rated at 7-9klbs as seen on 5500 door ...
Illustration of a ring-and-pinion differential for a rear-wheel drive vehicle Schematic diagram of a ring-and pinion differential. A relatively simple design of differential is used in rear-wheel drive vehicles, whereby a ring gear is driven by a pinion gear connected to the transmission.
The Dana 80 Trac Lok is unique being it is a 4 pinion unit, unlike other Dana Trac Lok units with 2 pinions. This was the only rear axle available for the 2nd generation Dodge Ram 3500 trucks. [2] 35 Spline Dana 80 in a 2002 Dodge 2500HD Diesel
This ring and pinion is significantly stronger with a better pinion to ring gear tooth contact patch and angle. It was typically used in the back of jeep JKs, Isuzus and Nissan pickups. This ring and pinion does share some components and can be adapted into an earlier Dana 44 but requires some work, different bearings and spacers.
Engaging clutch 1 (C1) grounds the ring gear (R). Motor B is used as the traction motor, driving the sun gear (S); since the ring gear is grounded, the pinion gears (P) are forced to turn, driving the wheels through a reducing gear and differential. CD2 (6) Two motor, electric-only No: Yes: No No M: M
Ads
related to: gm ring & pinion