Search results
Results from the WOW.Com Content Network
If the template has a separate documentation page (usually called "Template:template name/doc"), add [[Category:Political party templates]] to the <includeonly> section at the bottom of that page.
An assortment of PG cable glands.Similar glands with DIN/ISO metric threads are also available. The Stahlpanzerrohrgewinde (German: [ˈʃtaːlˌpantsɐʁoːɐ̯.ɡəˌvɪndə], "steel conduit thread") standard for screw threads, more often called by the shortened Panzergewinde (German: [ˈpantsɐɡəˌvɪndə]), was a technical standard created in Germany and subsequently used in Switzerland ...
[[Category:Political party templates by country]] to the <includeonly> section at the bottom of that page. Otherwise, add <noinclude>[[Category:Political party templates by country]]</noinclude> to the end of the template code, making sure it starts on the same line as the code's last character.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
If the template has a separate documentation page (usually called "Template:template name/doc"), add [[Category:Politics and government templates]] to the <includeonly> section at the bottom of that page. Otherwise, add <noinclude>[[Category:Politics and government templates]]</noinclude>
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
The design was first proposed by the British Association in 1884 [1] [2] with a thread angle and depth based on the Swiss Thury thread, [3] it was adopted by the Association in 1903. The Thury thread was different in that it went both positive and negative all the way up to a size of −20 which was 75.2 mm diameter by 8.23 mm pitch (p). The ...
Taller cards add a 133.35 mm, so that a double height card is 233.35 mm high and a triple 366.7 mm high. Enclosure heights are multiples of 3U, with the cards always 33.35 mm (1.313 in) shorter than the enclosure. Two common heights are 3U (a 100 mm card in a 5.25 in (133.35 mm) subrack) and 6U (a 233.35 mm card in a 10.5 in (266.70 mm) high ...