enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. SAE 316L stainless steel - Wikipedia

   en.wikipedia.org/wiki/SAE_316L_stainless_steel

   SAE 316L grade stainless steel, sometimes referred to as A4 stainless steel or marine grade stainless steel, is the second most common austenitic stainless steel after 304/A2 stainless steel. Its primary alloying constituents after iron , are chromium (between 16–18%), nickel (10–12%) and molybdenum (2–3%), up to 2% manganese , [ 1 ] with ...

3. Dowel bar retrofit - Wikipedia

   en.wikipedia.org/wiki/Dowel_bar_retrofit

   A dowel bar retrofit (DBR) is a method of reinforcing cracks in highway pavement by inserting steel dowel bars in slots cut across the cracks. It is a technique which several U.S. states' departments of transportation have successfully used in repairs to address faulting in older jointed plain concrete pavements.

4. Taper pin - Wikipedia

   en.wikipedia.org/wiki/Taper_pin

   A taper pin is a fastener used in mechanical engineering. They are steel rods with one end having a slightly larger diameter than the other. Metric taper pins have a taper of 1:50. [1] A 1:50 taper means that one end of a 50 mm long bar will be 1 mm smaller in diameter than the other end.

5. Surgical stainless steel - Wikipedia

   en.wikipedia.org/wiki/Surgical_stainless_steel

   SAE 316 and SAE 316L stainless steel, also referred to as marine grade stainless, is a chromium, nickel, molybdenum alloy of steel that exhibits relatively good strength and corrosion resistance. 316L is the low carbon version of 316 stainless steel. [2] 316L in particular is biocompatible when produced to ASTM F138 / F139. [3]

6. Treenail - Wikipedia

   en.wikipedia.org/wiki/Treenail

   The mortise is drilled 1 ⁄ 16 inch (1.6 mm) smaller than the treenail to create a tight fit and take advantage of friction in the mortise. In cases where the treenail is 24 inches (61 cm) or longer, the treenail should be shaped 1 ⁄ 8 inch (3.2 mm) smaller than the other half. In the same case the mortise is drilled in two parts, with a ...

7. Pin - Wikipedia

   en.wikipedia.org/wiki/Pin

   Patchwork pins: 22 (0.5 mm) 1 + 7 ⁄ 16 in (37 mm) Pins have extra sharp tips for penetrating thick iron-on patches; their size and length also make them suitable for quilting; they have glass heads that will not melt if pressed in an iron. Quilting pins: 30 (0.6 mm) 1 + 7 ⁄ 8 in (48 mm) Quilting pins are exceptionally long and often have ...