Search results
Results from the WOW.Com Content Network
Automotive aerodynamics is the study of the aerodynamics of road vehicles. Its main goals are reducing drag and wind noise, minimizing noise emission, and preventing undesired lift forces and other causes of aerodynamic instability at high speeds.
The tire model must produce realistic shear forces during braking, acceleration, cornering, and combinations, on a range of surface conditions. Many models are in use. Most are semi-empirical, such as the Pacejka Magic Formula model. Racing car games or simulators are also a form of vehicle dynamics simulation. In early versions many ...
In the first case the force is continuously applied to the car by a person, while in the second case the force is delivered in a short impulse. Contact forces are often decomposed into orthogonal components, one perpendicular to the surface(s) in contact called the normal force, and one parallel to the surface(s) in contact, called the friction ...
The effect of a fictitious force also occurs when a car takes the bend. Observed from a non-inertial frame of reference attached to the car, the fictitious force called the centrifugal force appears. As the car enters a left turn, a suitcase first on the left rear seat slides to the right rear seat and then continues until it comes into contact ...
Circle of forces. The circle of forces, traction circle, friction circle, [1] or friction ellipse [2] [3] [4] is a useful way to think about the dynamic interaction between a vehicle's tire and the road surface. The diagram below shows the tire from above, so that the road surface lies in the xy-plane.
The lift force is transmitted through the pressure, which acts perpendicular to the surface of the airfoil. Thus, the net force manifests itself as pressure differences. The direction of the net force implies that the average pressure on the upper surface of the airfoil is lower than the average pressure on the underside. [60]
Traction can also refer to the maximum tractive force between a body and a surface, as limited by available friction; when this is the case, traction is often expressed as the ratio of the maximum tractive force to the normal force and is termed the coefficient of traction (similar to coefficient of friction).
Similar to the "Belgian tourniquet" in cycling, the "slingshot pass" is the most dramatic and widely noted maneuver associated with drafting. A trailing car (perhaps pushed by a line of drafting cars) uses the lead car's wake to pull up with maximum momentum at the end of a straightaway, enters a turn high, and turns down across the lead car's ...