enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Vacuum servo - Wikipedia

   en.wikipedia.org/wiki/Vacuum_servo

   In the US it is commonly called a brake booster. A vacuum servo, also known as a power booster or power brake unit, uses a vacuum, usually supplied by the engine, to multiply the driver's pedal effort and apply that effort to the master cylinder .

3. Power brakes - Wikipedia

   en.wikipedia.org/wiki/Power_brakes

   Vacuum boosters provide brake assist for the driver by multiplying the force out of the booster creating more than the force that was used to push on the brake pedal. The booster works by pulling the air out of the booster chamber with a pump or other vacuum source (typically the engine's intake manifold [1]), creating a low-pressure system ...

4. Brake fluid pressure sensor - Wikipedia

   en.wikipedia.org/wiki/Brake_fluid_pressure_sensor

   The fault could be lack of hydraulic fluid, low brake fluid in the reservoir, a broken hydraulic line or a bad master brake cylinder. The sensor is used to detect pressure differentials in the hydraulic system. If the car alerts a fault in the hydraulic system and the system checks out, the sensor itself may have failed. [2]

5. Brake fade - Wikipedia

   en.wikipedia.org/wiki/Brake_fade

   Brake fade can be a factor in any vehicle that utilizes a friction braking system including automobiles, trucks, motorcycles, airplanes, and bicycles. Brake fade is caused by a buildup of heat in the braking surfaces and the subsequent changes and reactions in the brake system components and can be experienced with both drum brakes and disc ...

6. S-cam - Wikipedia

   en.wikipedia.org/wiki/S-cam

   An S-cam is part of a braking system used in heavy vehicles such as trucks and wheeled machinery. It consists of a shaft, usually around 4 to 25 inches long, turned at one end by means of an air-powered brake booster and lever with an S-shaped cam at the wheel end.

7. Brake pad - Wikipedia

   en.wikipedia.org/wiki/Brake_pad

   The concept of brake pads or disc brakes as an alternative to drum brakes had been around at least as early as a patent by F. W. Lanchester in 1902. [2] However, due to high cost and inefficiencies compared to drum brakes they were not commonly implemented until after World War II. [3]