enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rod end bearing - Wikipedia

   en.wikipedia.org/wiki/Rod_end_bearing

   A rod end bearing, also known as a heim joint (N. America) or rose joint (U.K. and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links , tie rods , or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect 90-degree alignment between the ...

3. Jeep Cherokee (XJ) - Wikipedia

   en.wikipedia.org/wiki/Jeep_Cherokee_(XJ)

   The Jeep Cherokee (XJ) is a sport utility vehicle manufactured and marketed across a single generation by Jeep in the United States from 1983 (model year 1984) through 2001 — and globally through 2014. It was available in two- or four-door, five-passenger, front-engine, rear- or four-wheel drive configurations.

4. Jeep Liberty (KJ) - Wikipedia

   en.wikipedia.org/wiki/Jeep_Liberty_(KJ)

   Intended as a replacement for the discontinued Jeep Cherokee (XJ), the Liberty was the first Jeep vehicle to use rack and pinion steering [4] and the two then-new PowerTech engines: the 150 horsepower (110 kW) 2.4 L straight-4, which was discontinued in 2006, and the 210 horsepower (160 kW) 3.7 L V6.

5. Dana 44 - Wikipedia

   en.wikipedia.org/wiki/Dana_44

   In the 1960s, Jeep used a unique Dana 44 IFS setup, that was short lived. In the 1980s and 1990s, Ford used a form of IFS known as " Twin Traction Beam " (TTB). This Dana 44 had no axle tubes but attached to the driver side traction beam, which also acted as a cover plate, and had "open air" axles which traveled through the beams to the spindles.

6. Steering linkage - Wikipedia

   en.wikipedia.org/wiki/Steering_linkage

   The steering linkage which connects the steering gearbox to the front wheels consists of a number of rods. These rods are connected with a socket arrangement similar to a ball joint, called a tie rod end, allowing the linkage to move back and forth freely so that the steering effort will not interfere with the vehicles up-and-down motion as the ...

7. Drag link - Wikipedia

   en.wikipedia.org/wiki/Drag_link

   Steering system showing drag link. A drag link converts rotary motion from a crank arm, to a second bellcrank, usually in an automotive steering system.. While the origin of the term is not clear, it pre-dates the automobile, and is described as in use in 1849 as a means of rotating a Ducie cultivator being operated by cable by stationary steam engine (or between engines).