Search results
Results from the WOW.Com Content Network
Moghadasi et alios [10] evaluated Corey, Chierici and LET correlations for oil/water relative permeability using a sophisticated method that takes into account the number of uncertain model parameters. They found that LET, with the largest number (three) of uncertain parameters, was clearly the best one for both oil and water relative permeability.
Craig [1] proposed three rules of thumb for interpretation of wettability from relative permeability curves. These rules are based on the value of interstitial water saturation, the water saturation at the crossover point of relative permeability curves (i.e., where relative permeabilities are equal to each other), and the normalized water permeability at residual oil saturation (i.e ...
The concept of permeability is of importance in determining the flow characteristics of hydrocarbons in oil and gas reservoirs, [4] and of groundwater in aquifers. [5]For a rock to be considered as an exploitable hydrocarbon reservoir without stimulation, its permeability must be greater than approximately 100 md (depending on the nature of the hydrocarbon – gas reservoirs with lower ...
Permeation will occur over time with the tires, so it is best to know the permeability of the material that will make up the tire with the desired gas to make the most efficient tires. Insulating material: Water vapour permeation of insulating material is important as well as for submarine cables to protect the conductor from corrosion.
All this requires different relative permeability curves for the x and z directions. Geological heterogeneities in the reservoirs like laminas or crossbedded permeability structures in the rock, also cause directional relative permeabilities. This tells us that relative permeability should, in the most general case, be represented by a tensor.
with is the oil saturation for a zero capillary pressure during the secondary drainage process, is the irreducible water saturation and is the residual non-wetting phase saturation after imbibition. A rock is defined as:
in which is the absolute permeability, is the relative permeability, φ is the porosity, and μ is the fluid viscosity. Rocks with better fluid dynamics (i.e., experiencing a lower pressure drop in conducting a fluid phase) have higher TEM versus saturation curves.
In petroleum engineering, the Leverett J-function is a dimensionless function of water saturation describing the capillary pressure, [1] = / where is the water saturation measured as a fraction, is the capillary pressure (in pascal), is the permeability (measured in m²), is the porosity (0-1), is the surface tension (in N/m) and is the contact angle.