Search results
Results from the WOW.Com Content Network
Clutch control refers to the act of controlling the speed of a vehicle with a manual transmission by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts ...
After bringing the engine up to speed in a gear, the driver senses the need to upshift. To get out of the current gear without using the clutch, the driver backs off slightly on the accelerator and gently pulls the gear stick toward the neutral position. If they back off enough, a moment comes when the engine is neither driving the car nor ...
Trained drivers of vehicles with non-synchronous transmissions sometimes use the techniques listed below. If improperly implemented, these techniques can cause damage to the vehicle or the loss of control of the vehicle. Double-clutching: releasing the clutch in neutral to synchronize the speeds of the shafts within the transmission [7]
A clutch is a mechanical device that allows an output shaft to be disconnected from a rotating input shaft. [1] The clutch's input shaft is typically attached to a motor, while the clutch's output shaft is connected to the mechanism that does the work. In a motor vehicle, the clutch acts as a mechanical linkage between the engine and ...
Before the introduction of transmission synchronizers in 1927, [2] double clutching was a technique required to prevent damage to an automobile's gearing during shifts. Due to the difficulty and most often unnecessary redundancy involved in the technique, coupled with the advent of synchronized gearing systems, it has largely fallen into disuse in light vehicles.
Most of these vehicles have a clutch and gearbox (or transmission) mounted directly on the engine, with a drive shaft leading to a final drive in the rear axle. When the vehicle is stationary, the drive shaft does not rotate. Some vehicles (generally sports cars, such as the Chevrolet Corvette C5/C6/C7, Alfa Romeo Alfetta and Porsche 924/944 ...
Heel-and-toe shifting is used before entry into a turn while a vehicle is under braking, preparing the transmission to be in the optimal range of rpm to accelerate out of the turn. One benefit of downshifting before entering a turn is to eliminate the jolt to the drivetrain, or any other unwanted dynamics.
It was a serious educational street driving simulator that used 3D polygon technology and a sit-down arcade cabinet to simulate realistic driving, including basics such as ensuring the car is in neutral or parking position, starting the engine, placing the car into gear, releasing the hand-brake, and then driving.