Search results
Results from the WOW.Com Content Network
In IPv6 this is the only standards-based form to denote network or routing prefixes. For example, the IPv4 network 192.0.2.0 with the subnet mask 255.255.255.0 is written as 192.0.2.0 / 24, and the IPv6 notation 2001:db8:: / 32 designates the address 2001:db8:: and its network prefix consisting of the most significant 32 bits.
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.
For example, in a network with multiple subnets where nodes A and B are located in one subnet and nodes C and D are in another, a partition occurs if the network switch device between the two subnets fails. In that case nodes A and B can no longer communicate with nodes C and D, but all nodes A-D work the same as before.
The network address and subnet mask of the interface, along with the interface type and number, are entered into the routing table as a directly connected network. A remote network is a network that can only be reached by sending the packet to another router. Routing table entries to remote networks may be either dynamic or static.
A layer-3 segment in an IP network is called a subnetwork, formed by all nodes sharing the same network prefix as defined by their IP addresses and the network mask. [5] Communication between layer-3 subnets requires a router. Hosts on a subnet communicate directly using the layer-2 segment that connects them.
There are several different non-equivalent definitions of "subnet" and this article will use the definition introduced in 1970 by Stephen Willard, [1] which is as follows: If = and = are nets in a set from directed sets and , respectively, then is said to be a subnet of (in the sense of Willard or a Willard–subnet [1]) if there exists a monotone final function: such that = ().
A network and wildcard mask combination of 1.1.1.1 0.0.0.0 would match an interface configured exactly with 1.1.1.1 only, and nothing else. Wildcard masks are used in situations where subnet masks may not apply. For example, when two affected hosts fall in different subnets, the use of a wildcard mask will group them together.
An example of route aggregation as a part of CIDR. A supernetwork, or supernet, is an Internet Protocol (IP) network that is formed by aggregation of multiple networks (or subnets) into a larger network. The new routing prefix for the aggregate network represents the constituent networks in a single routing table entry.