Search results
Results from the WOW.Com Content Network
The ADAT Lightpipe, officially the ADAT Optical Interface, is a standard for the transfer of digital audio between equipment. It was originally developed by Alesis but has since become widely accepted, [1] with many third party hardware manufacturers including Lightpipe interfaces on their equipment.
Most commonly used on professional microphones, the common 3-pin XLR connector is a standard for transferring balanced audio among professional audio equipment. The 4-pin XLR is the standard connector for intercom headsets, such as systems made by Clear-Com and Telex. Two pins are used for the mono headphone signal and two pins for the ...
USB was designed as a single connector to support all needs, including any generic data, audio/video, power, and more; DisplayLink is its most successful Audio+Video protocol. Until the 3.0 revision, very low data rates meant most A/V needed alternative connectors.
If the sound source is 340 meters from the microphone, then the sound arrives approximately 1 second later than the light. The AV-sync delay increases with distance. During mixing of video clips normally either the audio or video needs to be delayed so they are synchronized. The AV-sync delay is static but can vary with the individual clip.
Virtual Audio Cable is a software product based on WDM multimedia driver that allows a user to transfer audio streams from one application to another. Any application is able to send an audio stream to the input side of a "virtual cable" while a corresponding application can receive this stream from the output side.
A wireless microphone, or cordless microphone, is a microphone without a physical cable connecting it directly to the sound recording or amplifying equipment with which it is associated. Also known as a radio microphone , it has a small, battery-powered radio transmitter in the microphone body, which transmits the audio signal from the ...
In close miking, a microphone is placed relatively close to an instrument or sound source, within three to twelve inches, producing a dry or non-reverberant sound. [1] This serves to reduce extraneous noise, including room reverberation and is commonly used when attempting to record a number of separate instruments while keeping the signals ...
In audio and broadcast engineering, audio over Ethernet (AoE) is the use of an Ethernet-based network to distribute real-time digital audio.AoE replaces bulky snake cables or audio-specific installed low-voltage wiring with standard network structured cabling in a facility.