Search results
Results from the WOW.Com Content Network
The rudder is a fundamental control surface which is typically controlled by pedals rather than at the stick. It is the primary means of controlling yaw—the rotation of an airplane about its vertical axis. The rudder may also be called upon to counter-act the adverse yaw produced by the roll-control surfaces.
Several technology research and development efforts exist to integrate the functions of aircraft flight control systems such as ailerons, elevators, elevons, flaps and flaperons into wings to perform the aerodynamic purpose with the advantages of less: mass, cost, drag, inertia (for faster, stronger control response), complexity (mechanically ...
Collection of control yokes at Boeing Future of Flight Museum: 747, 707, B-29, Trimotor.The former two yokes are W-shaped, while the latter two are circular. The cockpit of Concorde, which has an M-shaped yoke mounted on a control column The cockpit of an Embraer ERJ with an M-shaped yoke "W"/"U" style yoke in a Cessna 152 light aircraft, mounted on a horizontal tube protruding from the ...
Cockpit controls and instrument panel of a Cessna 182D Skylane. Generally, the primary cockpit flight controls are arranged as follows: [2] A control yoke (also known as a control column), centre stick or side-stick (the latter two also colloquially known as a control or joystick), governs the aircraft's roll and pitch by moving the ailerons (or activating wing warping on some very early ...
The Northrop N-1M on display at the National Air and Space Museum's Steven F. Udvar-Hazy Center. A flying wing is an aeroplane that has no definite fuselage or tailplane, with its crew, payload, fuel, and equipment housed inside the main wing structure.
The asymmetric lift causes asymmetric drag, which causes the aircraft to yaw adversely. To correct the yaw, the pilot uses the rudder to perform a coordinated turn. In a multi-engined aircraft, the loss of thrust in one engine can also cause adverse yaw, and here again the rudder is used to regain coordinated flight.
Typical trim tabs on aileron, rudder and elevator. Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a particular desired attitude without the need for the operator to constantly apply a control force.
The vertical stabilizer is the fixed vertical surface of the empennage. A vertical stabilizer or tail fin [1] [2] is the static part of the vertical tail of an aircraft. [1] The term is commonly applied to the assembly of both this fixed surface and one or more movable rudders hinged to it.