enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. UHF connector - Wikipedia

    en.wikipedia.org/wiki/UHF_connector

    A typical SO-239 UHF female, properly hooded, has an impedance bump of about 35 ohms. The length of the bump is typically 1 ⁄ 2 inch, where the female pin flares to fit over the male pin. This bump can be mitigated by using a honeycomb dielectric in the female pin area. Many VHF/UHF amateur operators use special UHF females that maintain a 50 ...

  3. Stub (electronics) - Wikipedia

    en.wikipedia.org/wiki/Stub_(electronics)

    The free end of the stub is either left open-circuit, or short-circuited (as is always the case for waveguides). Neglecting transmission line losses, the input impedance of the stub is purely reactive ; either capacitive or inductive , depending on the electrical length of the stub, and on whether it is open or short circuit.

  4. List of RF connector types - Wikipedia

    en.wikipedia.org/wiki/List_of_RF_connector_types

    Mini-UHF connector, a smaller and much newer design than the standard UHF; SMA connector A 50 ohm screwed connection. The 0.9mm centre pin is the same diameter as the centre of RG402 Coax so that connections to that cable can be made with no discontinuity, forming the pin from the coax itself. Good to 18 GHz

  5. Impedance parameters - Wikipedia

    en.wikipedia.org/wiki/Impedance_parameters

    A Z-parameter matrix describes the behaviour of any linear electrical network that can be regarded as a black box with a number of ports.A port in this context is a pair of electrical terminals carrying equal and opposite currents into and out-of the network, and having a particular voltage between them.

  6. Twin-lead - Wikipedia

    en.wikipedia.org/wiki/Twin-lead

    Double-wire dipole whose characteristic impedance in free space is around 300 Ω. Dipole Although the center impedance at resonance is approximately 73 Ω in free space , in actual use it varies between 30 and 100 Ω , depending on height above ground, so with high-impedance feedline a T-match or Y-match feed will probably be necessary.

  7. Blackman's theorem - Wikipedia

    en.wikipedia.org/wiki/Blackman's_theorem

    Blackman's theorem is a general procedure for calculating the change in an impedance due to feedback in a circuit. It was published by Ralph Beebe Blackman in 1943, [1] was connected to signal-flow analysis by John Choma, and was made popular in the extra element theorem by R. D. Middlebrook and the asymptotic gain model of Solomon Rosenstark.

  8. 25 to watch in 2025 - AOL

    www.aol.com/25-watch-2025-181318561.html

    In the final days of the 2024 calendar, there's a lot to look forward to in the sports world in 2025. Field Level Media surveyed writers and editors in its network to come up with 25 to watch in ...

  9. N connector - Wikipedia

    en.wikipedia.org/wiki/N_connector

    Type N connector (female) The N connector (also, type-N connector) is a threaded, weatherproof, medium-size RF connector used to join coaxial cables.It was one of the first connectors capable of carrying microwave-frequency signals, and was invented in the 1940s by Paul Neill of Bell Labs, after whom the connector is named.