Search results
Results from the WOW.Com Content Network
Dry running protection, also known as dry-run protection or dry-running protection, is a type of protection mechanism to prevent a rotor, pump or stirrer shaft from operating without any medium added, as the bearing and shaft seal might be damaged if the motor is run while dry. [1]
Pump pressure, which is also referred to as system pressure loss, is the sum total of all the pressure losses from the oil well surface equipment, the drill pipe, the drill collar, the drill bit, and annular friction losses around the drill collar and drill pipe. It measures the system pressure loss at the start of the circulating system and ...
This tubing can be used as a kill string for chemical injection. The tubing may have a “no-go” nipple at the end as a means of pressure testing. Pumping flow: the tubing and pump are run to a depth beneath the working fluid. The pump and rod string are installed concentrically within the tubing.
This can either be a spring-loaded pressure sensor or an electronic pressure sensor, depending on the type of sending unit. Problems with the oil pressure sending unit or the connections between it and the driver's display can cause abnormal oil pressure readings when oil pressure is perfectly acceptable.
Indirect TPMS (iTPMS) systems do not use physical pressure sensors; they measure air pressures using software-based systems, which by evaluating and combining existing sensor signals such as wheel speeds, accelerometers, and driveline data to estimate and monitor the tire pressure without physical pressure sensors in the wheels.
The primary purpose of a wellhead is to provide the suspension point and pressure seals for the casing strings that run from the bottom of the hole sections to the surface pressure control equipment. [1] While drilling the oil well, surface pressure control is provided by a blowout preventer (BOP).
A non-exempt well is a well capable of producing more than 17.36 gallons per minute, and must submit semi-annual water well production reports to the District at a rate of $0.155 per 1,000 gallons.
A pumpjack is the overground drive for a reciprocating piston pump in an oil well. [1] It is used to mechanically lift liquid out of the well if there is not enough bottom hole pressure for the liquid to flow all the way to the surface. The arrangement is often used for onshore wells. Pumpjacks are common in oil-rich areas.