enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Anti-roll bar - Wikipedia

   en.wikipedia.org/wiki/Anti-roll_bar

   An anti-sway or anti-roll bar is intended to reduce the lateral tilt (roll) of the vehicle on curves, sharp corners, or large bumps. Although there are many variations in design, the object is to induce a vehicle's body to remain as level as possible by forcing the opposite wheel's shock absorber , spring, or suspension rod in the same ...

3. Panhard rod - Wikipedia

   en.wikipedia.org/wiki/Panhard_rod

   A Panhard rod (also called Panhard bar, track bar, or track rod) is a suspension link that provides lateral location of the axle. [1] Originally invented by the Panhard automobile company of France in the early twentieth century, this device has been widely used ever since.

4. Multi-link suspension - Wikipedia

   en.wikipedia.org/wiki/Multi-link_suspension

   Consequently, they react to loads along their own length, in tension and compression, but not in bending. Some multi-links do use a trailing arm, control arm or wishbone, which has two bushings at one end. On a front suspension one of the lateral arms is replaced by the tie-rod, which connects the rack or steering box to the wheel hub.

5. Suspension link - Wikipedia

   en.wikipedia.org/wiki/Suspension_link

   These links work in tandem with the coil springs, dampers, and sway bar to control all six degrees of freedom of the axle. The upper links (orange) and the lower links (yellow) work in tandem to control the pitch, yaw and the fore and aft movement (surge). The panhard rod (green) controls the left and right movement (sway). While the springs ...

6. Torsion bar suspension - Wikipedia

   en.wikipedia.org/wiki/Torsion_bar_suspension

   Torsion bar suspension inside Leopard 2 Schematic of a front axle highlighted to show torsion bar. A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end ...

7. Trailing-arm suspension - Wikipedia

   en.wikipedia.org/wiki/Trailing-arm_suspension

   Trailing-arm designs in live axle setups often use just two or three links and a Panhard rod to locate the wheel laterally. A trailing arm design can also be used in an independent suspension arrangement. Each wheel hub is located only by a large, roughly triangular arm that pivots at one point, ahead of the wheel. Seen from the side, this arm ...