Search results
Results from the WOW.Com Content Network
Porosity is a fraction between 0 and 1, typically ranging from less than 0.005 for solid granite to more than 0.5 for peat and clay. The porosity of a rock, or sedimentary layer, is an important consideration when attempting to evaluate the potential volume of water or hydrocarbons it may contain.
This porosity can range in size, from sub-micron to voids greater than 10 mm, depending on the casting. Casting defects caused by porosity can affect the part’s structural integrity, creating a failure point. Porosity can also prevent the part from being pressure tight. This will impact performance if the part is designed to hold gases or ...
For porosity testing, coatings can be single or multiple layers of any metal that is not corroded and sealed by a self-limiting reaction in the reducing sulfur environment of the FOS test. The simplest recommended technique is to identify any porosity of the coating as revealed by the presence of surface spots.
This article about materials science is a stub. You can help Wikipedia by expanding it.
Mill scale is a complex oxide that contains around 70% iron with traces of nonferrous metals and alkaline compounds. Reduced iron powder may be obtained by conversion of mill scale into a single highest oxide i.e. hematite (Fe 2 O 3) followed by reduction with hydrogen.
Hot isostatic pressing (HIP) is a manufacturing process, used to reduce the porosity of metals and increase the density of many ceramic materials. This improves the material's mechanical properties and workability. The process can be used to produce waste form classes.
The high cost of the material generally limits its use to advanced technology, aerospace, and manufacturing. Fine-scale open-cell foams, with cells smaller than can be seen unaided, are used as high-temperature filters in the chemical industry. Metal foams are used in compact heat exchangers to increase heat transfer at the cost of reduced ...
Gas porosity is the fraction of a rock or sediment filled with a gas.. Determining the true porosity of a gas filled formation has always been a problem in the oil industry. . While natural gas is a hydrocarbon, similar to oil, the physical properties of the fluids are very different, making it very hard to correctly quantify the total amount of gas in a formati