Ads
related to: ata hard drive connectortemu.com has been visited by 1M+ users in the past month
- Top Sale Items
Daily must-haves
Special for you
- Women's Clothing
Limited time offer
Hot selling items
- Crazy, So Cheap?
Limited time offer
Hot selling items
- Our Top Picks
Team up, price down
Highly rated, low price
- Top Sale Items
staples.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
The 40-pin IDE/ATA connection transfers 16 bits of data at a time on the data cable. The data cable was originally 40-conductor, but later higher speed requirements for data transfer to and from the hard drive led to an "ultra DMA" mode, known as UDMA.
ATA-2 also was the first to note that devices other than hard drives could be attached to the interface: 3.1.7 Device: Device is a storage peripheral. Traditionally, a device on the ATA interface has been a hard disk drive, but any form of storage device may be placed on the ATA interface provided it adheres to this standard.
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
The Serial ATA interface was designed primarily for interfacing with hard disk drives (HDDs), doubling its native speed with each major revision: maximum SATA transfer speeds went from 1.5 Gbit/s in SATA 1.0 (standardized in 2003), through 3 Gbit/s in SATA 2.0 (standardized in 2004), to 6 Gbit/s as provided by SATA 3.0 (standardized in 2009). [9]
1.8-inch drives with ZIF connectors were used in digital audio players, such as the iPod Classic, and subnotebooks. Later 1.8-inch drives were updated with a micro-SATA connector and up to 320GB of storage (Toshiba MK3233GSG). The 1.8-inch form factor was eventually phased out as SSDs became cheaper and more compact. [38]
The SCSI commands and responses are embedded in "packets" (hence "ATA Packet Interface") for transmission on the ATA cable. This interfaces ATA with any device class for which a SCSI command set has been defined. ATAPI devices are also "speaking ATA" because the ATA physical interface and protocol are still being used to send the packets.
Ads
related to: ata hard drive connectortemu.com has been visited by 1M+ users in the past month
staples.com has been visited by 100K+ users in the past month