enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   The socket-headed Robertson screws are self-centering and reduce cam out. They also stop a power tool when set, and can be more easily removed if painted over, or old and rusty. [3]: 85–86 In industry, they speed up production and reduce product damage. [3]: 85–86

3. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

4. Drilling - Wikipedia

   en.wikipedia.org/wiki/Drilling

   The key feature of gun drilling is that the bits are self-centering; this is what allows for such deep accurate holes. The bits use a rotary motion similar to a twist drill; however, the bits are designed with bearing pads that slide along the surface of the hole keeping the drill bit on center.

5. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Machine tapers can be grouped into self-holding and self-releasing classes. With self-holding tapers, the male and female wedge together and bind to each other to the extent that the forces of drilling can be resisted without a drawbar, and the tool will stay in the spindle when idle. It is driven out with a wedge when a tool change is needed.

6. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   While the above is a common use of center drill bits, it is a technically incorrect practice and should not be considered for production use. The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The ...

7. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Slot screw drives have a single horizontal indentation (the slot) in the fastener head and is driven by a "common blade" or flat-bladed screwdriver.This form was the first type of screw drive to be developed, and, for centuries, it was the simplest and cheapest to make because it can just be sawed or filed.