Search results
Results from the WOW.Com Content Network
English: Potential-flow streamlines around a NACA 0012 airfoil at 11° angle of attack, with upper and lower streamtubes identified. Computed using the Wolfram Demonstrations Project Code Potential Flow over a NACA Four-Digit Airfoil by Richard L. Fearn and beautified in Adobe Illustrator CS3.
TT: the maximum thickness in percent of chord, as in a four-digit NACA airfoil code. For example, the NACA 23112 profile describes an airfoil with design lift coefficient of 0.3 (0.15 × 2), the point of maximum camber located at 15% chord (5 × 3), reflex camber (1), and maximum thickness of 12% of chord length (12).
English: Selected airfoils in nature and various vehicles, with their approximate chord length indicated. Sources for the shapes of the airfoils: Low-speed ULM wing: drawn over own photo of low-cost, low-speed ultralight
For example, an airfoil of the NACA 4-digit series such as the NACA 2415 (to be read as 2 – 4 – 15) describes an airfoil with a camber of 0.02 chord located at 0.40 chord, with 0.15 chord of maximum thickness. Finally, important concepts used to describe the airfoil's behaviour when moving through a fluid are:
Laminar flow airfoil for a RC park flyer, laminar flow airfoil for a RC pylon racer, laminar flow airfoil for a manned propeller aircraft, laminar flow at a jet airliner airfoil, stable airfoil used for flying wings, aft loaded airfoil allowing for a large main spar and late stall, transonic supercritical airfoil, supersonic leading edge ...
This work has been released into the public domain by its author, F l a n k e r.This applies worldwide. In some countries this may not be legally possible; if so: F l a n k e r grants anyone the right to use this work for any purpose, without any conditions, unless such conditions are required by law.
English: Subsonic (1) and trans-sonic (2) airfoils at identical Mach number. A: Supersonic flow region . B: Shock wave . C: Area of stalled flow . On the trans-sonic (or supercritical) airfoil, the deceleration of the flow on the top surface, and the strength of the shockwave with which the flow returns to a subsonic regime, are reduced.
The profile was designed in 1922 by Virginius E. Clark using thickness distribution of the German-developed Goettingen 398 airfoil. [1] The airfoil has a thickness of 11.7 percent and is flat on the lower surface aft of 30 percent of chord. The flat bottom simplifies angle measurements on propellers, and makes for easy construction of wings.