enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Coping (joinery) - Wikipedia

   en.wikipedia.org/wiki/Coping_(joinery)

   Coping is only ever used for internal corners. External corners are always mitred. The main reason that scribed joints are used is that timber shrinks in width far more than it does in length. By using a scribed joint rather than an internal mitre joint, the effect of shrinkage is minimised. Also it is possible to arrange the scribed joints ...

3. Glossary of woodworking - Wikipedia

   en.wikipedia.org/wiki/Glossary_of_woodworking

   climb cut On a table saw or router, cutting against the normal feed direction at the end of the cut to prevent tearout. close grain Any wood grain with very fine fibers of cells that are not visibly porous. compass saw conversion The reduction of a whole log into pieces suitable for working. Conversion can be done in three basic ways: sawn ...

4. Fillet (mechanics) - Wikipedia

   en.wikipedia.org/wiki/Fillet_(mechanics)

   An interior or exterior corner, with an angle or type of bevel, is called a "chamfer". Fillet geometry, when on an interior corner is a line of concave function , whereas a fillet on an exterior corner is a line of convex function (in these cases, fillets are typically referred to as rounds).

5. Snipe (wood machining) - Wikipedia

   en.wikipedia.org/wiki/Snipe_(wood_machining)

   Released from this pressure, the table rises back up, here by about 0.004 inches. The table moving up decreases the height of the cutter head above the table, so the planer cuts more deeply and the sniped section of the trailing end begins. (The feed distance from A to D is 12 inches, the length of the workpiece.)

6. Dovetail joint - Wikipedia

   en.wikipedia.org/wiki/Dovetail_joint

   A finished dovetail joint Dovetailed woodworking joints on a Romanian church Stone pillar at the Vazhappally Maha Siva Temple. A dovetail joint or simply dovetail is a joinery technique most commonly used in woodworking joinery (carpentry), including furniture, cabinets, [1] log buildings, and traditional timber framing.

7. Lap joint - Wikipedia

   en.wikipedia.org/wiki/Lap_joint

   Lap joints can be used to join wood, plastic, or metal. A lap joint can be used in woodworking for joining wood together. A lap joint may be a full lap or half lap. In a full lap, no material is removed from either of the members that will be joined, resulting in a joint which is the combined thickness of the two members.

8. Rip cut - Wikipedia

   en.wikipedia.org/wiki/Rip_cut

   Rip cuts are commonly made with a table saw, but other types of power saws can also be used, including a radial arm saw, band saw, and hand held circular saw.In sawmills the head saw is the first rip-saw a log goes through, which is sometimes a gang-saw, and then the cants may be resawn using other saws and then edged in an edger and sometimes cut to length by a crosscut saw.

9. Chamfer - Wikipedia

   en.wikipedia.org/wiki/Chamfer

   In machining a chamfer is a slope cut at any right-angled edge of a workpiece, e.g. holes; the ends of rods, bolts, and pins; the corners of the long-edges of plates; any other place where two surfaces meet at a sharp angle. Chamfering eases assembly, e.g. the insertion of bolts into holes, or nuts.