Search results
Results from the WOW.Com Content Network
Message Signaled Interrupts (MSI) are a method of signaling interrupts, using special in-band messages to replace traditional out-of-band signals on dedicated interrupt lines. While message signaled interrupts are more complex to implement in a device, they have some significant advantages over pin-based out-of-band interrupt signalling, such ...
High speed mode is still designed to reduce power usage due to its low voltage signaling and parallel transfer ability. The communication protocol describes two sets of instructions. The Display Command Set (DCS) is a set of common commands for controlling the display device, and their format is specified by the DSI standard.
The Message Signaled Interrupts (MSI) feature of the PCI 2.2 and later specifications cannot be used without the local APIC being enabled. [8] Use of MSI obviates the need for an I/O APIC. Additionally, up to 224 interrupts are supported in MSI mode, and IRQ sharing is not allowed. [9]
If more data needs to be exchanged, the shift registers are reloaded and the process repeats. Transmission may continue for any number of clock cycles. When complete, the main stops toggling the clock signal, and typically deselects the sub. If a single sub device is used, its CS pin may be fixed to logic low if the sub permits it.
The serial ports are frequently disabled to free an IRQ line for another device. IRQ 2/9 is the traditional interrupt line for an MPU-401 MIDI port, but this conflicts with the ACPI system control interrupt (SCI is hardwired to IRQ9 on Intel chipsets); [6] this means ISA MPU-401 cards with a hardwired IRQ 2/9, and MPU-401 device drivers with a ...
SMM is a special-purpose operating mode provided for handling system-wide functions like power management, system hardware control, or proprietary OEM designed code. It is intended for use only by system firmware (BIOS or UEFI), not by applications software or general-purpose systems software. The main benefit of SMM is that it offers a ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
Initiator (INT) – This is the device that initiates a signaling procedure. Acceptor (ACP) – This is the device that shall respond to an incoming request from the INT; Note: the roles are not fixed to the devices. The roles are determined when you initiate a signaling procedure, and they are released when the procedure ends.