Search results
Results from the WOW.Com Content Network
The ring circuit is still the most common mains wiring configuration in the UK, although both 20 A and 30 A radial circuits are also permitted by the Wiring Regulations, with a recommendation based on the floor area served (20 A for area up to 25 m 2, 30 A for up to 100 m 2).
UK 230 volt domestic incoming underground electrical supply cable terminating in a service head with a 100 A main fuse on the line conductor (brown). The earthing system is TN-C-S per the green/yellow earthing conductor being connected within the neutral (blue conductor) side of the service head.
In an electrical power distribution system, a ring main unit (RMU) is a factory assembled, metal enclosed set of switchgear used at the load connection points of a ring-type distribution network. It includes in one unit two switches that can connect the load to either or both main conductors, and a fusible switch or circuit breaker and switch ...
Wired connections may also be connected to the final ring, requiring to include a suitably rated fuse and switch. The final ring circuit in the UK requires the use of BS 1363 plugs and sockets. However, the BS 1363 system is not limited to use with final ring circuits being suitable for radial circuits. [44]
The ring main is located well below most water mains, at a depth of 10 to 65 m (33 to 213 ft) below ground level and approximately 10 to 30 m (33 to 98 ft) below sea level. The tunnel is mostly of 2.54 m (100 in) internal diameter, except for the section between Ashford Common and Kew, where it is 2.91 m (115 in). [ 4 ]
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
Upgrade to a faster, more secure version of a supported browser. It's free and it only takes a few moments:
Diagram of a simple electrical cable with three insulated conductors, with IEC colour scheme. About 1950, PVC insulation and jackets were introduced, especially for residential wiring. About the same time, single conductors with a thinner PVC insulation and a thin nylon jacket (e.g. US Type THN, THHN, etc.) became common. [citation needed]