Search results
Results from the WOW.Com Content Network
At mid-range potential, the 10mm Auto produces energy higher than an average mainstream .357 Magnum. The 10mm is slightly less powerful than the .357 Magnum with high-performing commercially-available ammunition, or hand-loaded .357 magnums, and well below standard .41 Magnum rounds. The cartridge is considered to be high-velocity, giving it a ...
11 mm» This is a list of firearm cartridges which have bullets in the 10 millimetres (0.39 in) to 10.99 millimetres (0.433 in) caliber range. Length refers to the cartridge case length.
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
The 10mm cartridge and the 40 S&W are almost identical, but the 10mm case is longer and operates at a higher pressure. This means that you can use existing 357-Sig dies to re-form the straight-wall 10mm case into a shouldered .355" (9mm), and then the neck can be sized up to accept .358 rifle bullets.
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
ISO general purpose metric screw threads – Part 2: Nominal sizes for 0,2 mm, 0,25 mm and 0,35 mm fine pitch threads; nominal diameter from 1 mm to 50 mm: Active: DIN 13-3: ISO general purpose metric screw threads – Part 3: Nominal sizes for 0,5 mm fine pitch threads; nominal diameter from 3,5 mm to 90 mm: Active: DIN 13-4
In addition, 10 mm (0.393 in), and letter X (0.397 in) will work well, although major minus pitch by itself does not tell you this; but the 90% ± 2 pp guideline supports it. For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use.
40 mm grenade (×46 mm LV, ×51 mm MV, ×53 mm HV) Autocannons 20×102mm (STANAG 3585), 20 mm caliber; 25×137mm (STANAG 4173), 25 mm caliber;