enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Even on many drill presses, handheld drills, and lathes, which have chucks (such as a drill chuck or collet chuck), the chuck is attached by a taper. On drills, drill presses, and milling machines , the male member is the tool shank or toolholder shank, and the female socket is integral with the spindle.

3. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Triangle drill bit shank. The triangle shank is almost always made by machining three flats on round bar stock. It is intended as a minor modification of a straight shank, still allowing it to be held in a 3-jaw drill chuck, but allowing higher torque transmission and limited slipping. Can be held in a drill chuck; High torque transmission

4. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A pin chuck is a specialized chuck designed to hold small drills (less than 1 mm (0.039 in) in diameter) that could not be held securely in a normal drill chuck. The drill is inserted into the pin chuck and tightened; the pin chuck has a shaft which is then inserted into the larger drill chuck to hold the drill securely. Pin chucks are also ...

5. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.

6. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...

7. Magnetic drilling machine - Wikipedia

   en.wikipedia.org/wiki/Magnetic_drilling_machine

   A morse taper 3 arbor equipped magnetic drill machine using taper shank drill bits. The arbor or chuck on a magnetic drill is attached to the motor. It is a type of clamp used to attach the core drills. There are mainly two types of chuck available for the magnetic drill, industrial arbor (manual tightening) and quick change drill chucks.