Search results
Results from the WOW.Com Content Network
Miller twist rule is a mathematical formula derived by American physical chemist and historian of science Donald G. Miller (1927-2012) to determine the rate of twist to apply to a given bullet to provide optimum stability using a rifled barrel. [1]
Example of a ballistic table for a given 7.62×51mm NATO load. Bullet drop and wind drift are shown both in mrad and MOA.. A ballistic table or ballistic chart, also known as the data of previous engagements (DOPE) chart, is a reference data chart used in long-range shooting to predict the trajectory of a projectile and compensate for physical effects of gravity and wind drift, in order to ...
However, QuickLOAD has limitations, as it is merely a computer simulation. It does not account for different brands of primers for example, and its ability to predict the effect of seating bullets into the rifling is crude. A QuickLOAD user most certainly should not just "plug in" a cartridge, bullet and powder and use that load, assuming it is ...
For handgun cartridges, with heavy bullets and light powder charges (a 9×19mm, for example, might use 5 grains (320 mg) of powder, and a 115 grains (7.5 g) bullet), the powder recoil is not a significant force; for a rifle cartridge (a .22-250 Remington, using 40 grains (2.6 g) of powder and a 40 grains (2.6 g) bullet), the powder can be the ...
Example ballistic table for a given 7.62×51mm NATO load. Bullet drop and wind drift are shown both in mrad and moa. Milliradian adjustment is commonly used as a unit for clicks in the mechanical adjustment knobs (turrets) of iron and scope sights both in the military and civilian shooting sports. New shooters are often explained the principle ...
Tightness of shot groupings are calculated by measuring the maximum distance between any two bullet holes on the target (center-to-center) in length measurements such as millimeters or inches. Often that measurement is converted into angular measurements such as milliradians ("mils" or "mrads") or minutes of angle (MOAs), which expresses the ...
In the open division, IPSC has a lower power factor requirement of 160 kgr·ft/s for major, while the other IPSC handgun divisions require a power factor of 170 kgr·ft/s for major. Open and revolver are also the only divisions that allows major scoring with a 9 mm bullet diameter (the other handgun divisions require a 10 mm bullet diameter).
Sporting bullets, with a calibre d ranging from 4.4 to 12.7 millimetres (0.172 to 0.50 in), have C b in the range 0.12 lb/in 2 to slightly over 1.00 lb/in 2 (84 kg/m 2 to 703 kg/m 2). Those bullets with the higher BCs are the most aerodynamic, and those with low BCs are the least.