Search results
Results from the WOW.Com Content Network
Some devices with dual-band wireless network connectivity do not allow the user to select the 2.4 GHz or 5 GHz band (or even a particular radio or SSID) when using Wi-Fi Protected Setup, unless the wireless access point has separate WPS button for each band or radio; however, a number of later wireless routers with multiple frequency bands and ...
The performance of USB hard drives attached to an AirPort Extreme is slower than if the drive were connected directly to a computer. This is due to the processor speed on the AirPort Extreme. Depending on the setup and types of reads and writes, performance ranges from 0.5 to 17.5 MB/s for writing and 1.9 to 25.6 MB/s for reading. [8]
This notebook computer is connected to a wireless access point using a PC Card wireless card. An example of a Wi-Fi network. A wireless LAN (WLAN) is a wireless computer network that links two or more devices using wireless communication to form a local area network (LAN) within a limited area such as a home, school, computer laboratory, campus, or office building.
A router in a local area network (LAN) of a single organization is called an interior router. A router that is operated in the Internet backbone is described as exterior router. While a router that connects a LAN with the Internet or a wide area network (WAN) is called a border router, or gateway router. [24]
Linksys released its first Wi-Fi router in 2001 and has maintained early router releases for newer generations of Wi-Fi. [25] The WRT54G was notable for having firmware based on the Linux operating system. Since version 5, flash memory was reduced from 4 MB to 2 MB, and VxWorks was used instead of Linux. The original Linux model with 4 MB was ...
If a router finds a match, it will forward the packet through that route; if not, it will send the packet to its own default gateway. Each router encountered on the way will store the packet ID and where it came from so that it can pass the response packet back to the sender. The packet contains source and destination, not all router hops.
To do this, a router needs to search the routing information stored in its routing table. The routing table contains network/next hop associations. These associations tell a router that a particular destination can be optimally reached by sending the packet to a specific router that represents the next hop on the way to the final destination.