Search results
Results from the WOW.Com Content Network
At room temperature, it is a colorless gas, which forms white fumes of hydrochloric acid upon contact with atmospheric water vapor. Hydrogen chloride gas and hydrochloric acid are important in technology and industry. Hydrochloric acid, the aqueous solution of hydrogen chloride, is also commonly given the formula HCl.
They range from those of water at very low concentrations approaching 0% HCl to values for fuming hydrochloric acid at over 40% HCl. [ 31 ] [ 32 ] [ 33 ] Hydrochloric acid as the binary (two-component) mixture of HCl and H 2 O has a constant-boiling azeotrope at 20.2% HCl and 108.6 °C (381.8 K; 227.5 °F).
Baumé degrees (light) was calibrated with 0 °Bé (light) being the density of 10% NaCl in water by mass and 10 °Bé (light) set to the density of water. Consider, at near room temperature: +100 °Bé (specific gravity, 3.325) would be among the densest fluids known (except some liquid metals), such as diiodomethane .
A well-known example of a positive azeotrope is an ethanol–water mixture (obtained by fermentation of sugars) consisting of 95.63% ethanol and 4.37% water (by mass), which boils at 78.2 °C. [10] Ethanol boils at 78.4 °C, water boils at 100 °C, but the azeotrope boils at 78.2 °C, which is lower than either of its constituents. [11]
Water is an inorganic compound with the chemical formula H 2 O.It is a transparent, tasteless, odorless, [c] and nearly colorless chemical substance.It is the main constituent of Earth's hydrosphere and the fluids of all known living organisms (in which it acts as a solvent [20]).
A solution of nitric acid, water and alcohol, nital, is used for etching metals to reveal the microstructure. ISO 14104 is one of the standards detailing this well known procedure. [45] Nitric acid is used either in combination with hydrochloric acid or alone to clean glass cover slips and glass slides for high-end microscopy applications. [46]
The hydrogen fluoride (HF) gas is streamed into a wet (water) scrubber producing hydrofluoric acid. In both cases the phosphoric acid solution usually contains 23–33% P 2 O 5 (32–46% H 3 PO 4). It may be concentrated to produce commercial-or merchant-grade phosphoric acid, which contains about 54–62% P 2 O 5 (75–85% H 3 PO 4).
37.67 dyn/cm at 20 °C Viscosity [2] ... Gas properties ... Vapor-liquid Equilibrium for Formic acid/Water [4] P = 760 mmHg BP Temp. °C % by mole water