enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Attachment Unit Interface - Wikipedia

   en.wikipedia.org/wiki/Attachment_Unit_Interface

   In the case of incompatible fittings, the jackposts or sliding clip can be unscrewed and replaced, or adapter dongles and cables can be used. Electrically, the AUI's differential signals are designed for use with a 78 Ω cable and can transmit data between DTE and MAU at 10 Mbps over the standard's specified 50-meter length.

3. Ethernet over USB - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_USB

   Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.

4. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...

5. USB-to-serial adapter - Wikipedia

   en.wikipedia.org/wiki/USB-to-serial_adapter

   A USB-to-serial adapter or simply USB adapter is a type of protocol converter that is used for converting USB data signals to and from serial communications standards (serial ports). Most commonly the USB data signals are converted to either RS-232 , RS-485 , RS-422 , or TTL-level UART serial data.

6. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   The RJ45S jack mates with a keyed 8P2C modular plug, [18] [19] and has pins 4 and 5 (the middle positions) wired for the ring and tip conductors of a single telephone line and pins 7 and 8 shorting a programming resistor. This is a different mechanical interface and wiring scheme than ANSI/TIA-568 T568A and T568B schemes with the 8P8C connector ...

7. Medium-dependent interface - Wikipedia

   en.wikipedia.org/wiki/Medium-dependent_interface

   These are referred to as MDI and MDI-X (medium-dependent interface crossover). When connecting an MDI port to an MDI-X port, a straight-through cable is used, while to connect two MDI ports or two MDI-X ports, a crossover cable must be used. Conventionally, MDI is used on end devices and routers while MDI-X is used on hubs and switches.